DonnyFL | RONIN .357/.457/.50 [BIG BORE] Moderator

Ronin for the .357 is a redesign of the Ronin 1/2 x 20. If you do not like the length of the Emperor, this is an awesome alternative. Rear cap was also changed to reduce weight. 

• 2 x 6.25 inches 
• Available for .357/.457/.50 caliber airguns
• M18x1 threaded end cap
• Mono-core design to increase accuracy and limit the chances of pellet clipping
• No moving parts or epoxy that may become loose after 1000’s of rounds
• Precision CNC’d by professional machinist
• Sand blasted and anodized for maximum durability
• Take apart in less than 10 seconds by unscrewing the rear end cap and pushing back the mono-core. No silly hex key or torch needed when you want to perform maintenance inside the unit.
• Comes pre-wrapped in felt
• Machined grooves on the outside for easy handling.
• Weight 9.7 oz

*Note: If you see white lines on the inside of the front cap, that’s ok. Those were caused by the prongs holding the pieces while anodizing. They are not pellet clippings.